Usage instructions:
To calculate the amount of Doom Fogger needed: 1. Calculate the m2 size of the area by multiplying length and width of floor area, e.g. if a room is 4mx5m, the room is 20 m2. 2 Multiply the m2 by the ceiling height to get cubic metres, e.g. 60 m2 (floor area of the house or flat) x 3m (height of ceiling from floor) = 180 m3. 3. One can of Doom Fogger treats an area of 180 m3 (the average volume of a small house or flat). 4. Do not use more than 1 can of Doom Fogger for every 50 m3, e.g. if your ceiling is 3m high, do not use more than 1 can for every 16 m2 (approximately 4m x 4m) floor space. 5. To treat rooms smaller than 50 m2 (e.g. bathrooms, toilets, etc.), place Doom Fogger in an open area leading into the room (e.g. in the corridor, foyer, sitting room, etc.). Keep interleading doors open. Preparing for fumigation: Select a time when the area to be treated may be left isolated for 3 hours or more. Close all windows and doors. Open all inside doors leading to the areas to be treated. Open cupboards, cabinets, trunks to allow full penetration. Extinguish all flames. Switch off all electricity sources at the main distribution board. (If you use more than the recommended amount, fog may ignite if activated by a spark). Use paper to cover asphalt tiles, polished wooden floors and polished furniture. Selected position for the can in the centre of an area being treated. Place on a sheet of newspaper that has been spread on the floor. Read all warnings and precautions carefully and ensure these are followed before activating the Doom Fogger. Activating the doom fogger can: Shake well before use. Remove the cover and tilt the spray button away from your face. Push the spray button down with your thumb until it snaps into place a continuous spray will be emitted. Place can quickly in the selected position and the paper, leave the room immediately, closing the door behind you. Keep the treated area closed for at least 3 hours. After Treatment: At least 3 hours after treatment, open all doors and windows to ventilate the area. Vacate the area and allow at least 30 minutes before re-entering. Do not switch electricity on until area is well ventilated.

Storage instructions:
Store in a cool, dry place.

Warnings:
Do not spray on or near food, utensils, animals or plants. Remove pets and cover aquaria (fish tanks) before spraying. Avoid skin contact and excessive inhalation. If accidental skin contact should occur, wash thoroughly with soap and water. Do not use in the presence of persons with known sensitivity to pyrethroids. In case of signs of sensitivity, obtain medical advice. May stain plastic material and highly polished surfaces. Prevent excessive wetting of plastic/ rubber/asphalt surfaces. Keep away in a locked cupboard and wash hands after use. Extremely flammable aerosol. Pressurised container may burst if heated. Very toxic to aquatic life. If medical advice is needed, have product container or label at hand. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Do not spray on an open flame or other ignition source. Do not pierce or burn, even after use. Do not expose to temperatures exceeding 50°C. May cause irritation of the skin, eyes and mucous membranes and skin sensitisation. First aid: Excessive Inhalation: Remove person to fresh air and keep comfortable for breathing. If symptoms persist, seek medical advice. Skin Contact: Remove contaminated clothing and wash thoroughly with soap and water. Eye Contact: Rinse eyes with water as a precaution. If iritation occurs, seek medical advice. Keep out of reach of children, uninformed persons and animals

Ingredients:
Pyriproxyfen (Larvicide), D-Tetramethrin (Pyrethroid), Cyphenothrin (Pyrethroid), Pyriproxyfen (Larvicide)