Usage instructions:

Using the Callus Remover Attachment
The product is designed for smoothing coarse skin on the feet and heels. Do not use this device anywhere else on the body.
Wash the skin and dry fully. Note: Do not use on broken or bleeding skin.
Remove the protective cover from the unit, and it is ready to use.
Ensure the roller is placed onto the unit.
Turn on the unit by pressing the safety switch lock in the centre of the ON/OFF switch, and at the same time push the switch up.
Set a desired speed by pushing it up once for LOW speed, and push it up again for HIGH speed.
Gently roll back and forth or side to side on the callus/corn/hard skin area for 2-3 seconds.
Switch the machine off to check whether you have achieved the softness you desire. If not, go over the area for 2-3more seconds and check it again.
Continue to use this method until the level of smoothness is obtained.
Turn the unit off by pushing the switch all the way down (0). Rinse the skin or use a wet towel to get rid of the excess dead skin.
Using the Epilator Attachment
To turn on your unit, slide it up to the desired speed.
LOW is recommended for fine hair and HIGH is recommended for coarse hair.
(0) Power Off
(1) Low Speed
(2) High Speed
Hold the unit in your palm, at a 90’ angle. Position your Epilator so that the discs are upright.
The Epilator should be facing you.
To minimize discomfort, pull the skin taut surrounding the area you are moving hair from.
Gently glide the Epilator in short, quick, brush like or sweeping strokes in the direction of hair growth.
For your protection, your Epilator may slow down, or stop operating completely if it is pressed too hard against the skin.
Before removing hair from the bikini line and underarm area, it is important to use a loofa sponge in a warm shower or bath to remove dead skin and prevent ingrown hairs.
If it has been an extended amount of time since you have removed hair from your bikini line and underarms, trim the hair with a scissor or trimmer, and make sure to hold your skin taut with one hand while removing hair.
The Epilator is only intended to remove single hairs from the upper lip and chin.
Hold area taut and use small brushing motions.
Repeat within each area until all unwanted hair is removed.
The time required to remove unwanted hair depends on the users hair type.
After each use clean your Epilator.
Using the shaving head
You can use the shaving head to shave sensitive body parts, such as your underarms and bikini line.
With the shaving head, you can obtain a smooth result in a comfortable and gently way.
Make sure the appliance is switched off.
Remove the Epilating Head. (Press the Release Button and move the Epilating Head up)
Place the shaving head on the appliance and press it onto the appliance to snap home.
Place the shaving head onto your skin and move the appliance slowly and smoothly against the direction of hair growth.
Press the appliance lightly.

Information not available.